Article

  1. Home
  2. article
  3. How do we check the shaft sleeve during the use of the cone crusher

How do we check the shaft sleeve during the use of the cone crusher

ren

Margot

2020-09-12 00:57:54 1093

When the cone crusher is used, we need to do a lot of work. Today we are going to talk about the inspection of the cone crusher bushing. For the bushing, we need to do the following points. I hope we can all do well. Learn, and then make our cone crusher meet our requirements

1. If the outer cone of the eccentric shaft sleeve wears more than 3 mm, it should be replaced
2. The gap between the straight bushing and the eccentric bushing is more than twice the original assembly gap (see Table 3). The straight bushing has cracks and exceeds 13 perimeter or height. If there is one of the above, the straight bushing should be replaced.< br/>3. The gap between the cone sleeve and the upper part of the main shaft is more than twice the original assembly gap (see Table 3) or if there are serious cracks, the cone sleeve should be replaced.
4. The tooth thickness of the bevel gear is more than 20% worn , Should be replaced
5. The lower end thrust bearing pad of the eccentric bushing should be replaced if the non-parallel deviation of wear exceeds 0.1 mm or the thickness wear is more than 5 mm.
These are the issues we need to remember, When we use it, we can do as we said above, and finally make our cone crusher reach our goal and realize the value of our cone crusher. For more visit